1. The operator shall install some high-frequency eye protection devices, which can not only effectively protect the operator's eyes, but also effectively improve the operation speed and cutting quality. The cutting of industrial plates not only requires wearing eye protection devices under the stimulation of strong light, but also it is very necessary to use eye protection devices in the process of operating inline PCB cutting machine in order to effectively avoid some dust and impurities entering the eyes, which will affect the cutting work of operators.

2. During the use of the blade monving type machine, some safety devices should be properly installed, so as to effectively avoid the injury caused by human negligence. After all, it is inevitable for the most careful person to work carefully and occasionally neglect. With the safety devices, not only the safety of the operators can be effectively protected, but also the quality of the products can be guaranteed.

3. When the cutting distance is adjusted, it should not only be carried out according to the standard of the product to be cut, but also be operated correctly when it is processed, otherwise it is difficult to achieve the effect.

4. After the above steps have been adjusted, start cutting the boards. First, put the V-groove of the PCB board into the PCB depaneling machine, and then step on the foot pedal to close the board. Remember: the PCB does not move during the board cutting process, and the circular knife slides to ensure that the electronic components of the base plate are not damaged due to movement. Turn on the power supply and set the travel (determined by the size of PCB) and speed of the tool loading (when the speed light is green, it means low-speed operation, but on the contrary, it means high-speed operation);

5. Insert one end of the power line into the power socket of the V-Cut PCB separator machine body, and connect the other end with correct power supply; Connect the foot switch to the foot pedal, and do not turn on the power switch temporarily; Place the machine on a horizontal workbench, and ground the machine body to prevent static electricity; After each operation, remove the debris on the machine; If it is not used for a long time, the upper and lower knives shall be coated with protective oil to prevent rusting, and the sliding rail shall be filled with lubricating oil.