Introduction to the use of LED PCB separator machine

1. Place the LED PCB separator machine on a horizontal workbench, and ground the machine body to prevent static electricity.

2. Insert one end of the power cord into the power socket of the machine body, and connect the other end with 220V AC power supply; Connect the foot switch to the foot switch socket, and do not turn on the power switch temporarily.

3. Adjust the upper knife height according to the thickness of the PCB board. The best adjustment result is: place a paper with a thickness of 0.1mm on the lower knife, when the upper knife base is moved to slide, it is better to have clear, straight and uniform scratches on the paper.

4. Adjust the height of the front and rear supporting plates of the LED strip cutting machine according to the height of the components on the PCB. The front supporting plate can be operated freely without fatigue, and the rear supporting plate is easy without affecting the normal operation.

5. Turn on the power supply to set the travel (determined by the size of the PCB) and speed of the knife feeding (when the speed light is green, it is low-speed operation, but it is high-speed operation). After turning on the main power switch, the travel indicator light is travel a, and the travel needs to be changed according to the travel of the board. If travel B is required, first press the 4 travel key indicator light to flash as shown in the above figure, and then press the 3 travel key. If the indicator light is on, the setting is successful, C D. the same method is used for stroke setting.

6. Use both hands to clamp the V-CUT groove of the PCB to be separated on the lower blade within the upper blade travel (do not skew), and step on the foot switch with your foot.