Automatic Soldering Robot

Precautions for blade adjustment of LED PCB separator

May 19 , 2020
Precautions for blade adjustment of Aluminum LED PCB separator:


As we know that there are 3 upper blades and lower blades for this aluminum LED PCB separator. How should we adjust the blades?

aluminum led pcb separator

1. If the separated board is twisted, means that the three groups of knives are overcut, then we need to adjust the third upper knife, and raise the knife a little bit, so that the board can be cut without deformation.


2. If the separated board is bent, we need to adjust the two blocks on the right. If the board is concave bent, it means that the force of the block to the board edge is small. In this way, the block is closer to the board edge. If the convex bending occurs, it means that the force of the block to the board edge is large, then move the block out a little.


3. If the board is not cut off at one time, then we need to adjust the third upper knife down a little to make smaller blade clearance.

click here to leave a message

Leave A Message
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.

Home

Products

About

contact