What are the factors causing the high and low solder yield of the automatic soldering machine？

The output of traditional solder is unstable and fluctuates greatly, and there are many unstable factors. Moreover, there is much waste of solder wire, large consumption of soldering iron head and more capital investment. During the welding process, the automatic soldering robot machine will accurately repeat this action as long as the welding parameters and motion trajectory are given. During welding, the welding parameters of each weld are constant, and the weld quality is less affected by human factors, which reduces the requirements for workers' operation technology. Therefore, the soldering quality is stable. So what are the factors that cause the solder yield of the automatic soldering machine?

What are the factors causing the high and low solder yield of the automatic soldering robot machine:

1. Selection of solder wire (if the customer's existing tin wire fails to meet the requirements, the supplier shall cooperate in deployment or replacement, and the flux content of tin wire for automatic welding and manual welding is different).

2. For the selection of soldering table and soldering tip, different tips may be used for soldering tin of different products.

3. Fixture design will directly affect the accuracy and clamping efficiency of solder, that is, directly affect the work efficiency and yield of products.

4. Does the product of the automatic soldering robot machine form oxidation on the solder joints? Is the position error of product solder joint too large? It will also affect the yield of solder.

5. Experience of automatic soldering machine adjusting hand and maintenance of automatic soldering machine.

6. Whether the products of automatic soldering machine manufacturers operate stably.

The above content is an introduction to the factors causing the high and low solder yield of the automatic soldering robot machine. The output of the automatic soldering machine is stable, the product qualification rate is more than 98%, the consumables do not waste solder wire, and the soldering iron head is automatically protected. One time investment of funds has benefited for many years. The automatic soldering machine is a very complex process. We should adopt a scientific attitude during welding, and make targeted solutions and Countermeasures for the factors affecting the yield of soldering products, so as to achieve twice the result with half the effort, comprehensively improve the yield of products and save the cost of soldering.