What are the factors causing the high and low solder yield of the automatic soldering machine？ The output of traditional solder is unstable and fluctuates greatly, and there are many unstable factors. Moreover, there is much waste of solder wire, large consumption of soldering iron head and more capital investment. During the welding process, the automatic soldering robot machine will accurately r...
The quality of pulse head bonding machine mainly depends on the following factors: 1. The quality of temperature control system of pulse heat bonding machine. In the process of practical operation, if the temperature control system is damaged, whether the temperature is too high or too low, there will be a lot of unnecessary trouble in the process of practical operation. 2. The quality of thermode...
There are many ways of PCB depaneling. Whether it is manual breaking, knife depaneling or punch processing, it will cause certain damage or deformation to the circuit board itself, serious burrs on the cutting edge and dust, especially the disadvantages of traditional processing mode on PCB circuit boards welded with components are exposed. The emergence of PCB laser cutting machine has brought go...
The difference between blade moving type PCB depanelizer and guillotine type PCB depanelizer machine Same as the guillotine PCB depanelizer, the blade moving PCB depanelizer is now a common depaneling solution in the SMT equipment of the factory. We will explain the difference here: 1. Production technology The guillotine PCB depanelizer is generally pneumatically controlled, and the blade moving ...
There are three types of curve PCB separators for routed PCB boards: 1. First, it is the type of milling cutter automatic PCB router machine, which is suitable for segmentation and semi-finished products. Small cutting machine can be produced online, with fast cutting speed, high precision and simple operation. You can start production by exchanging fixtures. Use high-intensity dust collection sys...
Automatic PCB Router Delivery Automatic PCB router with dual tables shipped to Turkey. Precautions during operation of dual table automatic PCB router: First of all, as for the PCB router machinery itself, we need to conduct a comprehensive inspection of the PCB separator before operation. This step is not only used to check the specification of dual table automatic PCB router, but also to ensure ...
Process control of hotbar soldering ▪ Control the gap between the thermode head and the object to be pressed (usually PCB). When the thermode drops to the object to be pressed, it must be completely parallel to the object to be pressed, so that the object to be pressed can be heated evenly. The general method is to loosen the screws which are locked on hotbar soldering machine by the thermode firs...
PCB separator says no to defective products Over the years, in the whole automation market, there are a few automatic v-cut PCB separator products that cut corners and replace inferior ones with good ones. In fact, from the perspective of a manufacturer, this is a very irresponsible behavior, and it is also a deception to consumers. In recent years, it has been exposed on the Internet that the qua...
English
IPv6 network supported 